Component Description

Unit	Description
Combination meter	Controls the following with the signals received from each unit via CAN communication and the signals from switches and sensors.
	Speedometer	Tachometer
	Engine coolant temperature gauge	Fuel gauge
	Warning lamps	Indicator lamps
	Information display	Triple meter
Triple meter	Indicate the following with the signals received from combination meter via communication line and the signal from ignition power supply.
	Volt meter	Oil temperature gauge
	Clock
IPDM E/R	IPDM E/R reads the ON/OFF signals of the oil pressure switch and transmits the oil pressure switch signal to the combination meter via BCM with CAN communication line.
Fuel level sensor unit	Refer to Diagnosis Procedure .
Oil pressure switch	Refer to Diagnosis Procedure .
ECM	Transmits the following signals to the combination meter with CAN communication line.
	Engine speed signal	Engine coolant temperature signal
	Fuel consumption monitor signal	Oil temperature signal
	Shift position signal [with SyncroRev match mode (S-MODE) models]	Fuel filler cap warning display signal
ABS actuator and electric unit (control unit)	Transmits the vehicle speed signal to the combination meter with CAN communication line.
BCM	Transmits signals provided by various units to the combination meter with CAN communication line.
A/T shift selector	Transmits the following signal to the combination meter.
	Manual mode signal	Non-manual mode signal
	Manual mode shift up signal	Manual mode shift down signal
Paddle shifter	Transmits paddle shifter up signal and paddle shifter down signal to the combination meter.
TCM	Transmits the shift position signal to the combination meter with CAN communication line.
Washer level switch	Transmits the washer level signal to the combination meter.
Ambient sensor	Transmits the ambient sensor signal to the combination meter.
Brake fluid level switch	Transmits the brake fluid level switch signal to the combination meter.
Parking brake switch	Refer to Diagnosis Procedure .