Diagnosis Procedure

Transmits the parking brake switch signal to the combination meter.

1. CHECK COMBINATION METER INPUT SIGNAL 
   1. Start the engine.
   2. Check the voltage between combination meter harness connector and ground.

      Terminals			Condition		Voltage (Approx.)
      (+)		(-)
      Combination meter		Ground
      Connector	Terminal
      M54	26	Ground	Engine idling	When parking brake is applied	0 V
      				When parking brake is released	12 V

   Is the inspection result normal?

   YES

   INSPECTION END

   NO

   GO TO 2.

2. CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect combination meter connector and parking brake switch connector.
   3. Check continuity between combination meter harness connector and parking brake switch harness connector.

      Terminals				Continuity
      Combination meter		Parking brake switch
      Connector	Terminal	Connector	Terminal
      M54	26	M68	1	Existed

   4. Check continuity between combination meter harness connector and ground.

      Terminals			Continuity
      Combination meter		Ground
      Connector	Terminal
      M54	26	Ground	Not existed

   Is the inspection result normal?

   YES

   INSPECTION END

   NO

   Repair harness or connector.