DTC Confirmation Procedure

Is it necessary to erase permanent DTC?

YES

GO TO 3.

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect ECT sensor harness connector.
3. Remove ECT sensor. Refer to WATER OUTLET : Exploded View .
4. Check resistance between ECT sensor terminals by heating with hot water as shown in the figure.

   Courtesy of NISSAN NORTH AMERICA, INC.

   ECT sensor		Condition		Resistance (kOhm)
   +	-
   Terminal
   1	2	Temperature [ deg. C (deg. F)]	20 (68)	2.37 - 2.63
   			50 (122)	0.68 - 1.00
   			90 (194)	0.236 - 0.260

Is the inspection result normal?

YES

INSPECTION END

NO

Proceed to DTC Diagnosis Procedure 

If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

• Before performing the following procedure, do not add fuel.
• Before performing the following procedure, check that fuel level is between 1/4 and 4/4.
• Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

GO TO 4.

1. Move the vehicle to a cool place.
   NOTE: Cool the vehicle in an environment of ambient air temperature between -10 deg. C (14 deg. F) and 35 deg. C (95 deg. F).
2. Turn ignition switch OFF and leave the vehicle for 12 hours.
   CAUTION: Never turn ignition switch ON during this procedure.
   NOTE: The vehicle must be cooled with the hood open.
3. Start engine and let it idle for 20 minutes or more.
   CAUTION: Never turn ignition switch OFF during idling.
4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Proceed to DTC Diagnosis Procedure 

NO

INSPECTION END