Component Inspection
WARNING: This page is about a different variant/trim than selected.
- CHECK OVERDRIVE CONTROL SWITCH (PART 1)
Check continuity between CVT shift selector connector terminals.
CVT shift selector
Condition
Continuity
1 - 2
Overdrive control switch is pressed
Existed
Overdrive control switch is released
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- CHECK OVERDRIVE CONTROL SWITCH (PART 2)
- Remove selector lever knob. Refer to CVT SHIFT SELECTOR : Exploded View .
- Check continuity between wires of selector lever knob
.
Condition
Continuity
Overdrive control switch is pressed
Existed
Overdrive control switch is released
Not existed
Is the inspection result normal?
YES
Replace CVT shift selector assembly. Refer to CVT SHIFT SELECTOR : Removal & Installation .
NO
Replace selector lever knob. Refer to CVT SHIFT SELECTOR : Exploded View .