Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK DTC (TCM)
With CONSULT
1. Turn ignition switch ON.
2. Check "Self Diagnostic Results" in "TRANSMISSION".
Is any DTC detected?

YES

Check DTC detected item. Refer to DTC Index .

NO

GO TO 2.
CHECK DTC (COMBINATION METER)
With CONSULT

Check "Self Diagnostic Results" in "METER/M&A".

Is any DTC detected?

YES

Check DTC detected item. Refer to DTC Index .

NO

GO TO 3.
CHECK COMBINATION METER INPUT SIGNAL
With CONSULT
1. Shift the selector lever to "D" position.
2. Select "Data Monitor" in "METER/M&A".
3. Select "O/D OFF IND".
4. Check that "O/D OFF IND" turns ON/OFF when overdrive control switch is operated. Refer to Values On The Diagnosis .
Is the inspection result normal?

YES

Replace combination meter. Refer to COMBINATION METER : Removal & Installation .

NO

GO TO 4.
CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
1. Select "Data Monitor" in "TRANSMISSION".
2. Select "SPORT MODE SW".
3. Check that "SPORT MODE SW" turns ON/OFF when overdrive control switch is operated. Refer to Values On The Diagnosis Tool .
Is the inspection result normal?

YES

Replace combination meter. Refer to COMBINATION METER : Removal & Installation .

NO

Check overdrive control switch. Refer to Diagnosis Procedure .