PR25DD engine: Installation

WARNING: This page is about a different variant/trim than selected.

Install new transmission range switch.
CAUTION: Do not reuse transmission range switch.

NOTE: Ensure bolts are loose enough for the transmission range switch to pivot easily.
Install the manual lever.
NOTE: Do not install the nut or the lock washer.
Use the manual lever to shift the CVT into Neutral (N).
Remove the manual lever.
Assemble Tool.

Tool number

:--(J-52306)

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: Ensure pin (A) is threaded into gauge (B) as shown.
Place Tool (A) onto the manual shaft (B) while inserting its pin in the hole of the transmission range switch.

Tool number

:--(J-52306)

Courtesy of NISSAN NORTH AMERICA, INC.
Tighten bolts (A) to specification and remove Tool. Refer to Exploded View .

Tool number

:--(J-52306)

Courtesy of NISSAN NORTH AMERICA, INC.
Install the manual lever and lock washer and tighten nut to specification. Refer to Exploded View .
CAUTION: Do not reuse lock washer.
Install remaining components in reverse order of removal.