PR25DD engine
WARNING: This page is about a different variant/trim than selected.
- CHECK AIR FUEL RATIO SENSOR 1 POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect air fuel ratio (A/F) sensor 1 harness connector.
- Turn ignition switch ON.
- Check the voltage between A/F sensor 1 harness connector and ground.
+
-
Voltage
A/F sensor 1
Connector
Terminal
F44
4
Ground
Battery voltage
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 2.
- CHECK AIR FUEL RATIO SENSOR 1 POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect IPDM E/R harness connector.
- Check the continuity between A/F sensor 1 harness connector and IPDM E/R harness connector.
A/F sensor 1
IPDM E/R
Continuity
Connector
Terminal
Connector
Terminal
F44
4
F10
75
Existed
- Also check harness for short to ground and short to power.
Is the inspection result normal?
YES
Perform trouble diagnosis for power supply circuit.
NO
Repair or replace malfunctioning part.
- CHECK A/F SENSOR 1 INPUT SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between A/F sensor 1 harness connector and ECM harness connector.
A/F sensor 1
ECM
Continuity
Connector
Terminal
Connector
Terminal
F44
1
F90
86
Existed
2
88
- Check the continuity between A/F sensor 1 harness connector and ground, or ECM harness connector and ground.
A/F sensor 1
--
Continuity
Connector
Terminal
F44
1
Ground
Not existed
2
ECM
--
Continuity
Connector
Terminal
F90
86
Ground
Not existed
88
- Also check harness for short to ground and short to power.
Is the inspection result normal?
YES
GO TO 4.
NO
Repair or replace malfunctioning part.
- REPLACE A/F SENSOR 1
Replace malfunctioning A/F sensor 1. Refer to Exploded View .
INSPECTION END