PR25DD engine

WARNING: This page is about a different variant/trim than selected.

CHECK CRANKSHAFT POSITION SENSOR-1
1. Turn ignition switch OFF.
2. Loosen the fixing bolt of the sensor.
3. Disconnect crankshaft position sensor harness connector.
4. Remove the sensor.
5. Visually check the sensor for chipping.
Is the inspection result normal?

YES

GO TO 2.

NO

Replace crankshaft position sensor. Refer to Exploded View .

CHECK CRANKSHAFT POSITION SENSOR-2

Check the resistance between crankshaft position sensor terminals as per the following.

Crankshaft position sensor		Resistance [at 25 deg. C (77 deg. F)]
+	-
Terminal (Polarity)
1	2	Except 0 or INF.Ohm
	3
2	3

Is the inspection result normal?

YES

INSPECTION END

NO

Replace crankshaft position sensor. Refer to Exploded View .