PARKING BRAKE SHOE : Removal & Installation: Removal

WARNING:

Clean brakes using a vacuum dust collector to minimize the hazard of airborne particles or other materials.
Clean dust on disc brake rotor, parking brake shoes, and back plate using a dust collector. Do not blow with compressed air.

Remove the rear wheel and tire using power tool. Refer to Removal and Installation .
Place matching marks (A) on the rear disc brake rotor and on the wheel hub and bearing.

Courtesy of NISSAN NORTH AMERICA, INC.
Remove the rear disc brake rotor. Refer to Removal and Installation .
CAUTION:
- Do not depress brake pedal while brake caliper is removed.
- Set the parking brake control in the completely released position.
- Do not drop the removed parts.
If the rear disc brake rotor cannot be removed, use the following procedure:

Courtesy of NISSAN NORTH AMERICA, INC.
1. Secure the rear disc brake rotor using wheel nuts and remove the adjuster hole plug.
2. Using a suitable tool, rotate the adjuster (RH/LH) (1) in the direction (B) to retract and loosen the parking brake shoes.
3. Remove the rear disc brake rotor.
Remove the following parts. Refer to Exploded View .
- Anti-rattle pins
- Anti-rattle spring retainers
- Anti-rattle springs
- Return springs (upper/lower)
CAUTION: Do not drop the removed parts.
Remove the pin and separate the parking brake rear cable (RH/LH) from the toggle lever. Refer to Exploded View .
CAUTION:
- To prevent damage to parts, do not bend parking brake cables.
- Do not drop the removed parts.
Remove the following parts:
- Toggle lever
- Adjuster (RH/LH)
- Parking brake shoe (front)
- Parking brake shoe (rear)
CAUTION:
- The parking brake shoe (front) has a different lining material than the parking brake shoe (rear). Do not misidentify them during removal.
- Do not drop the removed parts.
If necessary, remove the nuts and the anchor block.
If necessary, remove the back plate. Refer to Removal and Installation .
Inspect the components. Refer to Inspection .