With Electric Parking Brake
WARNING:
Since dust covering the rear brakes has an effect on the human body, the dust must be removed using a dust collector. Do not splatter the dust with an air blow gun.
- When the parking brake is operated, the electric parking brake indicator lamp in the combination meter and the electric parking brake switch indicator turn ON.
- When the following malfunctions occur in the electric parking brake system, the brake system warning lamp (yellow) turns ON, the electric parking brake indicator lamp turns ON/OFF (depends on the electric parking brake system) or blinks, and the electric parking brake switch indicator blinks:
- When a status cannot be judged between applied and released.
- When the electric parking brake switch is operated under the condition that the electric parking brake switch is malfunctioning.
- When the electric parking brake switch is operated under the condition that the parking brake actuator is malfunctioning.
- When the initial position adjustment of the parking brake actuator is incomplete.
- The rear brake caliper can be released using CONSULT. Perform the "RELEASE OF REAR BRAKE CALIPER". Refer to Diagnosis Description .
- When the parking brake must be released while the battery negative terminal is disconnected or if a malfunction occurs in the electric parking brake system, the parking brake can be mechanically released. Perform the "INSTRUCTIONS FOR RELEASING PARKING BRAKE WHERE PARKING BRAKE SWITCH CANNOT BE USED". Refer to Work Procedure .
- When the electric parking brake control module is replaced, perform the "ADDITIONAL SERVICE WHEN REPLACING ELECTRIC PARKING BRAKE CONTROL MODULE". Refer to Work Procedure .