Component Function Check

DATA MONITOR

CONSULT

Select "Data Monitor" mode of "AUTO DRIVE POS.".
Select "LIFT RR SW-UP", "LIFT RR SW-DN".

Check that the function operates normally according to the following conditions:

Monitor item	Condition		Status
LIFT RR SW-UP	Lifting switch rear (up)	Operate	ON
LIFT RR SW-UP	Lifting switch rear (up)	Release	OFF
LIFT RR SW-DN	Lifting switch rear (down)	Operate	ON
LIFT RR SW-DN	Lifting switch rear (down)	Release	OFF

Is the inspection result normal?

YES

Inspection End.

NO

Perform diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .