Diagnostic Test

With CONSULT 

1. Park the vehicle on a level surface.
2. Turn ignition switch ON.
3. Select "Data Monitor" in "TRANSMISSION".
4. Select "G SEN SLOPE".
5. Swing the vehicle and check if value varies between - 40.45% and 40.45%.

   Monitor item	Condition	Standard
   G SEN SLOPE	Flat road	0%
   	Uphill	Positive value (Maximum 40.45%)
   	Downhill	Negative value (Minimum - 40.45%)

Is the inspection result normal?

YES 

GO TO STEP 2  .

NO 

GO TO STEP 3  .

With CONSULT 

1. Select "Self Diagnostic Results" in "TRANSMISSION".
2. Touch "Erase".

Perform "G SENSOR CALIBRATION". Refer to WORK PROCEDURE .

1. Remove G sensor. REMOVAL AND INSTALLATION .
2. Connect the all connectors.
3. Turn ignition switch ON.
4. Check voltage between TCM harness connector terminal and ground.
   Fig 1: Checking G Sensor (With Consult-III)

   Courtesy of NISSAN NORTH AMERICA, INC.

   : Direction of gravitational force

   +		-	Condition	Voltage (Approx.)
   TCM
   Connector	Terminal
   F44	14	Ground	Vertical (- 1G) (A)	1.17 V
   			Horizontal (B)	2.5 V
   			Vertical (1G) (C)	3.83 V

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Replace G sensor.REMOVAL AND INSTALLATION .

With CONSULT 

1. Install G sensor. REMOVAL AND INSTALLATION .
2. Select "Self Diagnostic Results" in "TRANSMISSION".
3. Touch "Erase".

Perform "G SENSOR CALIBRATION". Refer to WORK PROCEDURE .