Work Procedure

1. Park the vehicle on a level surface.
2. Adjust air pressure of all tires to the specified pressure. TIRE AIR PRESSURE .

GO TO STEP 2  .

With CONSULT

1. Turn ignition switch ON.
   CAUTION:

   Never start engine.

2. Select "Work Support" in "TRANSMISSION".
3. Select "G SENSOR CALIBRATION".
4. Touch "Start".
   CAUTION:

   Never swing the vehicle during "G sensor calibration".

Is "COMPLETED" displayed?

YES 

GO TO STEP 3  .

NO 

Perform steps 1 and 2 again.

With CONSULT

1. Turn ignition switch OFF and wait for 10 seconds.
2. Turn ignition switch ON.
3. Select "Self Diagnostic Results" in "TRANSMISSION".

Is "P1586" or "P1588" detected?

YES 

Go to DTC INDEX .

NO 

Calibration end