Diagnostic Test
- CHECK OUTPUT SPEED SENSOR POWER CIRCUIT
- Turn ignition switch OFF.
- Disconnect output speed sensor connector.
- Turn ignition switch ON.
- Check voltage between output speed sensor harness connector terminal and ground.
+ - Voltage Output speed sensor Connector Terminal F41 3 Ground 10 - 16 V
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
GO TO STEP 6 .
- CHECK OUTPUT SPEED SENSOR GROUND CIRCUIT
Check continuity between output speed sensor harness connector terminal and ground.
Output speed sensor - Continuity Connector Terminal F41 1 Ground Existed Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace malfunctioning parts.
- CHECK CIRCUIT BETWEEN OUTPUT SPEED SENSOR AND TCM (PART 1)
- Turn ignition switch OFF.
- Disconnect TCM connector.
- Check continuity between output speed sensor harness connector terminal and TCM harness connector terminal.
Output speed sensor TCM Continuity Connector Terminal Connector Terminal F41 2 F44 24 Existed
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair or replace malfunctioning parts.
- CHECK CIRCUIT BETWEEN OUTPUT SPEED SENSOR AND TCM (PART 2)
Check continuity between output speed sensor harness connector terminal and ground.
Output speed sensor - Continuity Connector Terminal F41 2 Ground Not existed Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Repair or replace malfunctioning parts.
- CHECK TCM INPUT SIGNALS
- Connect all of disconnected connectors.
- Lift the vehicle.
- Start the engine.
- Check frequency of output speed sensor.
+ - Condition Frequency
(Approx.)TCM Connector Terminal F44 24 Ground - Selector lever: "L" position
- Vehicle speed: 20 km/h (12 MPH)
200 Hz
Is the inspection result normal?
YES
Check intermittent incident. Refer to INTERMITTENT INCIDENT .
NO
Replace output speed sensor. Refer to REMOVAL AND INSTALLATION .
- CHECK CIRCUIT BETWEEN IPDM E/R AND OUTPUT SPEED SENSOR
- Disconnect IPDM E/R connector.
- Check continuity between IPDM E/R harness connector terminal and output speed sensor harness connector terminal.
IPDM E/R Output speed sensor Continuity Connector Terminal Connector Terminal E45 21 F41 3 Existed
Is the check result normal?
YES
GO TO STEP 7 .
NO
Repair or replace malfunctioning parts.
- DETECT MALFUNCTIONING ITEMS
Check the following items:
- Open circuit or short circuit in harness between ignition switch and IPDM E/R. Refer to WIRING DIAGRAM -IGNITION POWER SUPPLY - .
- Short circuit in harness between IPDM E/R harness connector terminal 21 and output speed sensor harness connector terminal 3.
- 10A fuse (No. 49, IPDM E/R). Refer to IPDM E/R TERMINAL ARRANGEMENT .
- IPDM E/R
Is the check result normal?
YES
Check intermittent incident. Refer to INTERMITTENT INCIDENT .
NO
Repair or replace malfunctioning parts.