Diagnosis Procedure

1. Start engine.
2. Check the operation of the brake warning lamp while operating the parking brake.

   Condition	Warning lamp status
   Parking brake applied	ON
   Parking brake released	OFF

   Is the inspection result normal? 

   YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".

   NO: GO TO 2.

Check the parking brake switch. Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 3.

NO: Replace parking brake switch.

1. Turn ignition switch OFF.
2. Check the parking brake switch signal circuit. Refer to "DIAGNOSIS PROCEDURE ".

   Is the inspection result normal? 

   YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness or connector.