LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Automatic Transmission) >> Shift Lock Release Replacement

Shift Lock Release Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your hands or gloves.
  1. Remove the shift lever (see SHIFT LEVER REMOVAL  ).
  2. Remove the A/T gear position indicator panel, (see SHIFT LEVER BOOT AND A/T GEAR POSITION INDICATOR PANEL REPLACEMENT  )
  3. Remove the shift lock release (A), and replace it.
    Fig 1: Locating Shift Lock Release Lower Point And Shift Lock Release
    G08057582Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Apply silicone grease to the shift lock release lower point (B), and install the shift lock release.
  5. Install the A/T gear position indicator panel (see SHIFT LEVER BOOT AND A/T GEAR POSITION INDICATOR PANEL REPLACEMENT  ).
  6. Install the shift lever (see SHIFT LEVER INSTALLATION  ).
scientia non olet · About LEMON Manuals