LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Gauges) >> Self-diagnostic Function >> Entering the self-diagnostic function (manual method)

Entering the self-diagnostic function (manual method)

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push and hold the SELECT/RESET button.
  2. Turn the combination light switch () ON.
  3. Turn the ignition switch to ON (II).
  4. Within 5 sec, turn the combination light switch () OFF, then ON and OFF again.
  5. Within 5 sec, release the SELECT/RESET button, and then push and release the button three times repeatedly.
NOTE:
  • While in the self-diagnostic mode, the dash lights brightness controller operates normally.
  • While in the self-diagnostic mode, the SELECT/RESET button is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check.
  • If the vehicle speed exceeds 1.2 mph (2 km/h) or the ignition switch is turned to LOCK (0), the self-diagnostic mode ends.
Fig 1: Identifying Vehicle Speed Ignition Switch - Blinking Pattern
G05960124Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals