LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Gauges) >> Rewriting the ODO Data and Transferring the Maintenance Minder Data To a New Gauge Control Module >> Rewriting and Transferring

Rewriting and Transferring

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before replacing the gauge control module, connect the HDS.
  2. Select GAUGES from the BODY ELECTRICAL system select menu with the HDS.
  3. Select Gauge Control Module Replacement (ODO Rewrite) from the ADJUSTMENT menu, and follow the instructions on the display to retrieve the ODO value and the Maintenance Minder Information.
  4. Replace the gauge control module.
  5. Follow the instructions on the display to write the new ODO value and Maintenance Minder Data to the new gauge control module. If the data transfer fails, refer to the instructions below to release the locked ODO value.
scientia non olet · About LEMON Manuals