Display area picture has lines or has shifted
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Check the vehicle battery condition first
BATTERY TEST
).
- Turn the ignition switch to ON (II), then push the REAR PWR button ON.
Does the screen open and come ON?
YES -Go to step 2.
NO -Go to RES power will not turn on
- Check if the screen has lines or has the image shifted.
Is the screen image normal?
YES -Operation is normal at this time.
NO -Go to step 3.
- Check the screen mode set up (refer to the
Owner's Manual for more information).
Are the settings set properly?
YES -Adjust the display settings, and recheck the function.
NO -Substitute a known-good rear controller and screen , and recheck. If the symptom/indication goes away, replace the original rear controller and screen