The BSI indicator does not go off, or does not come on
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- If the system malfunctions, always check for DTCs with the HDS.
- If a DTC is stored, troubleshoot the DTC first.
- Turn the ignition switch to ON (II), then wait for 10 seconds.
- Check that the BSI indicator comes on for about 2-5 seconds and then goes off.
Does the BSI Indicator go off?
YES -The system is OK.
NO -Go to step 3.
- Check for DTCs with the HDS (see General Troubleshooting Information
).
Are any DTCs Indicated?
YES -Troubleshoot the indicated DTC(s).
NO -Go to step 4
- Do the gauge control module self-diagnostic function (see
SELF-DIAGNOSTIC FUNCTION
).
Does the side BSI indicator flash?
YES -Replace the BSI control unit
NO -Replace the gauge control module, and recheck.