LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Blind Spot Information System (BSI)) >> BSI Control Unit Removal/Installation

BSI Control Unit Removal/Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left rear side trim panel (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
  2. With active damper system: Remove the active damper control unit (see ACTIVE DAMPER CONTROL UNIT REPLACEMENT ).
  3. Remove the bolts from the rear side trim panel support bracket (A) that holds the BSI control unit (B).
    Fig 1: Identifying Support Bracket And BSI Control Unit
    G08055738Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the 16P connector from the BSI control unit.
  5. Remove the BSI control unit from the rear side trim panel support bracket.
  6. Install the unit in the reverse order of removal.
scientia non olet · About LEMON Manuals