Third Row Seat-Back Recline Cable Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Take care not to kink the cable.

Remove the third row seat-back recline lever (see THIRD ROW SEAT-BACK RECLINE LEVER REPLACEMENT ).
While holding the lever (A) open, carefully pry out the cover (B) with trim tool to release the tabs (C), then remove the cover.

Fig 1: Holding Lever And Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the recline cable (A).

Fig 2: Disconnecting Recline Cable
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the cable in the reverse order of removal, and note these items:
- Make sure the cable is connected securely.
- Make sure the seat unlatches properly and latches securely.