LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (SRS (Supplemental Restraint System)) >> Side Airbag Replacement >> Removal

Side Airbag Replacement: Removal

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the battery terminal disconnection procedure (see USING THE GR8 BATTERY DIAGNOSTIC STATION ), then wait at least 3 minutes before starting work.
  2. Remove the front seat (see FRONT SEAT REMOVAL/INSTALLATION )
  3. Remove the seat-back cover/pad (see FRONT SEAT-BACK COVER REPLACEMENT )
  4. Pull the side airbag harness (A) out through the hole (B) in the reinforcing cloth of the seat-back cover/pad (C), then remove the side airbag (D).
    Fig 1: Pulling Side Airbag Harness Out Through Hole In Reinforcing Cloth Of Seat-Back Cover/Pad
    G08058506Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals