Driver's Seat Position Sensor Replacement: Removal

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

Raise the seat all the way up.
Do the battery terminal disconnection procedure (see USING THE GR8 BATTERY DIAGNOSTIC STATION ), then wait at least 3 minutes before starting work.
Remove the driver's seat (see FRONT SEAT REMOVAL/INSTALLATION ).
Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).

Fig 1: Identifying Driver's Seat Wire Harness 2P Connector, Driver's Seat Position Sensor And TORX Bolt
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the TORX bolt (C) using a TORX T30 bit, then remove the driver's seat position sensor.