DTC 71-1x ("x" can be 0 thru 9 or A thru F): Open in the Driver's Seat Position Sensor

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed (see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
Before doing this troubleshooting procedure, review SRS PRECAUTIONS AND PROCEDURES , GENERAL TROUBLESHOOTING INFORMATION , and Battery Terminal Disconnection and Reconnection (see USING THE GR8 BATTERY DIAGNOSTIC STATION ).
Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software (see SRS UNIT UPDATE ), and retest.

Clear the DTCs with the HDS (see HOW TO CLEAR DTCS ).
Turn the ignition switch to ON (II), then wait for 10 seconds.
Check for DTCs with the HDS (see HOW TO CLEAR DTCS ).
Is DTC 71-1x indicated?

YES -Go to step 5.

NO -Intermittent failure, the system is OK at this time. Go to TROUBLESHOOTING INTERMITTENT FAILURES . If another DTC is indicated, troubleshoot the DTC.
Turn the ignition switch to LOCK (0).
Check the connection between the driver's seat wire harness 2P connector and the driver's seat position sensor, and the ground connection at G602.
Are the connections OK?

YES -Go to step 6.

NO -Repair the poor connections and retest.
Clear the DTCs with the HDS (see HOW TO CLEAR DTCS ).
Check for DTCs with the HDS (see HOW TO CLEAR DTCS ).
Is DTC 71-1x indicated?

YES -Go to step 8.

NO -Intermittent failure, the system is OK at this time. Go to TROUBLESHOOTING INTERMITTENT FAILURES . If another DTC is indicated, troubleshoot the DTC.
Turn the ignition switch to LOCK (0), then wait for 10 seconds.
Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B) (see DRIVER'S SEAT POSITION SENSOR REPLACEMENT ).

Fig 1: Identifying Driver's Seat Wire Harness 2P Connector And Driver's Seat Position Sensor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a jumper wire between driver's seat wire harness 2P connector terminals No. 1 and No. 2.

Fig 2: Identifying Driver's Seat Wire Harness 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the negative cable from the battery, then wait at least 3 minutes.
Disconnect SRS unit connector B (39P) from the SRS unit (see DISCONNECTING SYSTEM CONNECTORS ).
Measure the resistance between body ground and SRS unit connector B (39P) terminal No. 23

Fig 3: Measuring Resistance Between Body Ground And SRS Unit Connector B (39P) Terminal No. 23
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Is there less than 1.0 Ω?

YES -Faulty driver's seat position sensor or SRS unit; replace the driver's seat position sensor (see DRIVER'S SEAT POSITION SENSOR REPLACEMENT ), then clear the DTC. If the problem is still present, replace the SRS unit (see SRS UNIT REPLACEMENT ).

NO -Open in the floor wire harness or the driver's seat wire harness; check for a poor ground at G602. if the ground is OK, replace the faulty harness, then clear the DTC.