Removal and Installation of Valve Oil Seal: Removal

Remove camshafts. Refer to "COMPONENT ".
Remove valve lifters. Refer to VALVE LIFTER OUTER DIAMETER .
Rotate crankshaft, and set piston whose valve oil seal is to be removed to TDC. This will prevent valve from dropping into cylinder.
CAUTION: When rotating crankshaft, be careful to avoid scarring front cover with timing chain.
Remove valve collet.
- Compress valve spring using Tool, the attachment and the adapter (A). Remove valve collet with a suitable magnet hand (B).
  CAUTION: When working, be careful not to damage valve lifter holes.
  
  Tool number : KV101092S0 (J-26336-B)
  
  Fig 1: Removing Valve Collet With Suitable Magnet Hand
  Courtesy of NISSAN MOTOR CO., U.S.A.
Remove valve spring retainer, valve spring and valve spring seat.
Remove valve oil seal using Tool (A).
Tool number :KV10107902 (J-38959)

Fig 2: Removing Valve Oil Seal Using Tool
Courtesy of NISSAN MOTOR CO., U.S.A.