LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (Qr25DE)) >> Service Information >> Drive Belts >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the drive belt onto all of the pulleys except for the water pump pulley. Install the drive belt onto water pump pulley last.
    CAUTION: Confirm drive belt is completely set on the pulleys.
  2. Release drive belt auto-tensioner, and apply tension to drive belt.
    WARNING: Never place hand in a location where pinching may occur if the holding tool accidentally comes off.
    CAUTION: Make sure no engine oil and engine coolant are adhered to drive belt and each pulley groove.
  3. Turn crankshaft pulley clockwise several times to equalize tension between each pulley.
  4. Confirm tension of drive belt at indicator is within the allowable use range. Refer to "CHECKING DRIVE BELTS ".
  5. Install the splash shield (RH). Refer to "COMPONENT ".
scientia non olet · About LEMON Manuals