Pinion Bearing Preload
- Remove the pinion sleeve assembly. Refer to "DISASSEMBLY ".
- Rotate the companion flange back and forth 2 to 3 times. Check for unusual noise, rotation malfunction, and other malfunctions.
- Rotate the companion flange at least 20 times to check for smooth operation of the bearing.
- Measure the drive pinion bearing preload with the preload gauge (A) [SST: ST3127S000 (J-25765-A)].
Standard
Preload torque : Refer to "PRELOAD TORQUE ".
CAUTION:- Every rotational part shall rotate smoothly with the specified gear oil.
- Preload torque differs before disassembly and after reassembly.
- If measured value is out of the specification, disassemble the pinion sleeve assembly to check and adjust each part.