LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Rear Final Drive: R145 >> On-Vehicle Repair >> Front Oil Seal >> Installation

Front Oil Seal: Installation

  1. Install front oil seal until it becomes flush with the coupling cover end, using the drifts.
    Fig 1: Installing Front Oil Seal
    G05892855Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION:
    • Never reuse oil seal.
    • When installing, never incline oil seal.
    • Apply multi-purpose grease onto oil seal lips, and gear oil onto the circumference of oil seal.
  2. Align the matching mark of electric controlled coupling with the matching mark of companion flange, then install the companion flange.
  3. Install companion flange lock nut with a flange wrench (commercial service tool), tighten to the specified torque.
    CAUTION: Never reuse companion flange lock nut.
  4. Install rear propeller shaft. Refer to "EXPLODED VIEW ".
  5. When oil leaks while removing, check oil level after the installation. Refer to "INSPECTION ".
    Fig 2: Aligning Matching Mark Of Electric Controlled Coupling
    G04921349Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals