Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Install front oil seal (1) to front cover using the drift (A) [SST: KV38102100 (J-25803-01)].
Dimension "H" : 8.55 - 9.55 mm (0.3366 - 0.3760 in)

CAUTION: Never incline front oil seal.
Install front cover gasket and front cover to transmission case.
CAUTION:
- Never reuse front cover gasket.
- Never damage front oil seal.
- Remove any moisture, oil, or foreign material adhering to both mating surfaces.
  
  Fig 1: Identifying Front Cover Gasket Dimension
  Courtesy of NISSAN MOTOR CO., U.S.A.
Temporarily tighten mounting bolt (<==) and sealing bolt (1).

Fig 2: Locating Transmission Case Mounting Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Temporarily tighten mounting bolts (<==) and sealing bolts (1).

Fig 3: Locating Transmission Case Mounting Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Tighten mounting bolts (<==) and sealing bolts (1) to the specified torque in the numerical order as shown in the figure.
Install transmission assembly. Refer to "WITHOUT S-MODE : REMOVAL AND INSTALLATION " (Without S-MODE) or "WITH S-MODE : REMOVAL AND INSTALLATION " (With S-MODE).
Refill gear oil. Refer to "REFILLING ".

Fig 4: Locating Transmission Assembly Mounting Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.