LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (Qr25DE)) >> Drive Belts >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Hook the auxiliary drive belt onto all of the pulleys except for the water pump pulley. Hook the drive belt onto water pump pulley last.
    CAUTION: Confirm belts are completely set on the pulleys.
  2. Release tensioner, and apply tensions to belt.
    CAUTION:
    • Avoid placing hand in a location where pinching may occur if the holding tool accidentally comes off.
    • Do not loosen the auto-tensioner pulley bolt. (Don't turn it counterclockwise. If turned counter-clockwise, the complete auto-tensioner must be replaced as a unit, including pulley.
  3. Turn crankshaft pulley clockwise several times to equalize tension between each pulley.
  4. Confirm tensions of belt at indicator is within the allowable use range. Refer to "CHECKING DRIVE BELTS ".
scientia non olet · About LEMON Manuals