LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System >> Brake Tube And Hose >> Front Brake Tube and Hose >> Installation

Front Brake Tube and Hose: Installation

  1. Assemble union bolt and copper washers to brake hose.
  2. Position the L-shape metal fitting of the brake hose to the brake caliper assembly positioning hole.
  3. Tighten union bolt to the specified torque. Refer to "HYDRAULIC CIRCUIT ".
  4. Connect brake hose to brake tube on vehicle, and temporarily tighten flare nut by hand as much as possible.
  5. Secure it with lock plate.
  6. Tighten flare nut to the specified torque with a flare nut torque wrench. Refer to "HYDRAULIC CIRCUIT ".
  7. Install brake hose to vehicle, and tighten nuts to the specified torque.
    Fig 1: Identifying Union Bolt And Copper Washer
    G04927301Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Bleed air from brake system. Refer to "BLEEDING BRAKE SYSTEM ".
scientia non olet · About LEMON Manuals