LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System >> Brake Pedal >> Inspection and Adjustment >> Adjustment

Inspection and Adjustment: Adjustment

  1. Loosen stop lamp switch and ASCD switch (if equipped) by rotating it counterclockwise by 45°.
  2. Loosen lock nut on input rod, then rotate input rod to set pedal to the specified height, and tighten lock nut.
    CAUTION: Make sure that the threaded end of input rod stays inside clevis.

    Lock nut : Refer to  "COMPONENTS ".

  3. With the pedal pulled and held by hand, press stop lamp switch or ASCD switch (if equipped) until its threaded end contacts brake pedal lever.
  4. With the threaded end of stop lamp switch or ASCD switch (if equipped) contacting brake pedal lever, rotate the switch clockwise by 45° to secure.
    CAUTION: Make sure that the clearance (C) is within the standard. Refer to "BRAKE PEDAL ".
  5. Check the pedal play.
    CAUTION: Make sure that stop lamps go off when brake pedal is released.
    Fig 1: Identifying Brake Pedal Lever And Lock Nut
    G04927292
  6. Start engine to check brake pedal depressed height. Refer to "BRAKE PEDAL ".
scientia non olet · About LEMON Manuals