LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 3.5L) >> DTC P0605: ECM >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECTION START 

    With CONSULT-II 

    1. Turn ignition switch ON.
    2. Select "SELF DIAG RESULTS" mode with CONSULT-II.
    3. Touch "ERASE".
    4. Perform DTC Confirmation Procedure. 

      See DTC CONFIRMATION PROCEDURE .

    5. Is the 1st trip DTC P0605 displayed again?

    With GST 

    1. Turn ignition switch ON.
    2. Select MODE 4 with GST.
    3. Touch "ERASE".
    4. Perform DTC Confirmation Procedure. 

      See DTC CONFIRMATION PROCEDURE .

    5. Is the 1st trip DTC P0605 displayed again?

    Yes or No

    1. Yes : GO TO 2.
    2. No : INSPECTION END 
  2. REPLACE ECM 
    1. Replace ECM.
    2. Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Refer to "NVIS (NISSAN VEHICLE IMMOBILIZER SYSTEM - NATS) ".
    3. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
    4. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
    5. Perform "IDLE AIR VOLUME LEARNING ".
    1. : INSPECTION END 
scientia non olet · About LEMON Manuals