With CONSULT-II

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch ON and wait at least 1 second.
Select "DATA MONITOR" mode with CONSULT-II.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and wait at least 1 second.
Repeat step 2 and 3 for 32 times.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

Fig 1: CONSULT-II Diagnosis Function Display (3 Of 3)
Courtesy of NISSAN MOTOR CO., U.S.A.