Procedure "B"
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch OFF. Disconnect cooling fan motor No. 1 harness connector and cooling fan motor No. 2 harness connector. See Figure .
- Disconnect IPDM E/R harness connectors E118 and E123. See COMPONENT LOCATIONS
. Check harness continuity between the following:
- Cooling fan motor No. 1 connector terminal No. 2 and IPDM E/R connector terminal No. 11. See WIRING DIAGRAMS . Continuity should exist.
- Check harness continuity between cooling fan motor No. 1 connector terminal No. 3 and IPDM E/R connector terminal No. 9. See WIRING DIAGRAMS . Continuity should exist.
- Cooling fan motor No. 2 connector terminal No. 2 and IPDM E/R connector terminal No. 10. Continuity should exist.
- Cooling fan motor No. 2 connector terminal No. 3 and IPDM E/R connector terminal No. 12. Continuity should exist.
- IPDM E/R connector terminal No. 14 and ground. Continuity should exist.
- Also check harness for short to ground and short to power.
- If circuit checks OK, go to COOLING FAN MOTORS (NO. 1 & 2) . If problem is found in circuit, repair open circuit or short to ground or short to power in harness or connectors.