LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (LAN System) >> Can >> Component Diagnosis >> Abs Branch Line Circuit >> Diagnosis Procedure >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CONNECTOR
    1. Turn the ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side).

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Repair the terminal and connector.

  2. CHECK HARNESS FOR OPEN CIRCUIT
    1. Disconnect the connector of ABS actuator and electric unit (control unit).
    2. Check the resistance between the ABS actuator and electric unit (control unit) harness connector terminals.
    RESISTANCE SPECIFICATION

    ABS actuator and electric unit (control unit) harness connector Resistance (Ω)
    Connector No. Terminal No.
    E26 26 15 Approx. 54 - 66

    Is the measurement value within the specification? 

    YES: GO TO 3.

    NO: Repair the ABS actuator and electric unit (control unit) branch line.

  3. CHECK POWER SUPPLY AND GROUND CIRCUIT

    Check the power supply and the ground circuit of the ABS actuator and electric unit (control unit). Refer to "WIRING DIAGRAM ".

    Is the inspection result normal? 

    YES (Present error): Replace the ABS actuator and electric unit (control unit). Refer to "EXPLODED VIEW ".

    YES (Past error): Error was detected in the ABS actuator and electric unit (control unit) branch line.

    NO: Repair the power supply and the ground circuit.

scientia non olet · About LEMON Manuals