Trouble Diagnoses Symptom Chart (With Front Left and Right Only Power Window Anti-pinch System)

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Check that other systems using the signal of the following systems operate normally.

FRONT LEFT AND RIGHT ONLY POWER WINDOW ANTI-PINCH SYSTEM

Symptom	Repair order	Refer to
None of the power windows can be operated using any switch	1. BCM power supply and ground circuit check	BCM POWER SUPPLY AND GROUND CIRCUIT CHECK
	2. Main power window and door lock/unlock switch supply and ground circuit check	MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH POWER SUPPLY CIRCUIT CHECK SYSTEM
	3. Power window serial link check	POWER WINDOW SERIAL LINK CHECK FRONT LH AND RH
Front power window LH alone does not operate	1. Front power window motor LH circuit check	FRONT POWER WINDOW MOTOR LH CIRCUIT CHECK
Front power window LH alone does not operate	2. Replace main power window and door lock/unlock switch	-
Front power window RH alone does not operate	1. Power window and door lock/unlock switch RH power and ground circuit check	POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH POWER SUPPLY AND GROUND CIRCUIT CHECK
	2. Power window serial link check	POWER WINDOW SERIAL LINK CHECK FRONT LH AND RH
	3. Front power window motor RH circuit check	FRONT POWER WINDOW MOTOR RH CIRCUIT CHECK
	4. Replace BCM	REMOVAL AND INSTALLATION
Rear power window LH alone does not operate	1. Rear power window motor LH circuit check	REAR POWER WINDOW MOTOR LH CIRCUIT CHECK (WITH FRONT LEFT AND RIGHT ONLY POWER WINDOW ANTI-PINCH SYSTEM)
Rear power window RH alone does not operate	1. Rear power window motor RH circuit check	REAR POWER WINDOW MOTOR RH CIRCUIT CHECK (WITH FRONT LEFT AND RIGHT ONLY POWER WINDOW ANTI-PINCH SYSTEM)
Anti-pinch system does not operate normally (Front LH)	Door window sliding part malfunction A foreign material adheres to window glass or glass run rubber. Glass run rubber wear or deformation. Sash is tilted too much, or not enough.	-
	2. Limit switch adjusting	SETTING OF LIMIT SWITCH
	3. Limit switch circuit check front LH	LIMIT SWITCH CIRCUIT CHECK FRONT LH
	4. Encoder circuit check front LH	ENCODER CIRCUIT CHECK FRONT LH
Anti-pinch system does not operate normally (Front RH)	Door window sliding part malfunction A foreign material adheres to window glass or glass run rubber. Glass run rubber wear or deformation. Sash is tilted too much, or not enough.	-
	2. Limit switch adjusting	SETTING OF LIMIT SWITCH
	3. Limit switch circuit check front RH	LIMIT SWITCH CIRCUIT CHECK FRONT LH
	4. Encoder circuit check front RH	ENCODER CIRCUIT CHECK FRONT RH
Power window retained power operation does not operate properly	1. Check the retained power operation mode setting.	ACTIVE TEST
	2. Door switch check	DOOR SWITCH CHECK
	3. Replace BCM.	REMOVAL AND INSTALLATION
Does not operate by front door lock assembly LH (key cylinder switch)	1. Front door lock assembly LH (key cylinder switch) check	FRONT DOOR LOCK ASSEMBLY LH (KEY CYLINDER SWITCH) CHECK
	2. Replace main power window and door lock/unlock switch	-
Power window lock switch does not function	1. Power window lock switch circuit check	POWER WINDOW SERIAL LINK CHECK FRONT LH AND RH