Power Window and Door Lock/Unlock Switch RH Power Supply and Ground Circuit Check
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK POWER SUPPLY CIRCUIT
- Turn ignition switch ON.
- Check voltage between power window and door lock/unlock switch RH connector D105 terminal 10 and ground.
10 - Ground: Battery voltage
Fig 1: Checking Voltage Between Power Window And Door Lock/Unlock Switch RH Connector Terminal 10 And GroundCourtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK: GO TO 2.
NG: Repair or replace harness.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect front power window switch RH.
- Check continuity between power window and door lock/unlock switch RH connector D105 terminal 11 and ground.
11 - Ground: Continuity should exist.
Fig 2: Checking Continuity Between Power Window And Door Lock/Unlock Switch RH Connector D105 Terminal 11 And GroundCourtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK: GO TO 3.
NG: Repair or replace harness.
- CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH POWER SUPPLY CIRCUIT
- Disconnect BCM and power window and door lock/unlock switch RH.
- Check continuity between BCM connector and power window and door lock/unlock switch RH connectors.BCM CONNECTOR AND POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH
Connector Terminal Connector Terminal Continuity A B BCM: M20 69 Power window and door lock/unlock switch RH: D105 10 Yes - Check continuity between BCM and ground.BCM AND GROUND
Connector Terminal Ground Continuity A BCM: M20 69 No
OK or NG
OK: GO TO 4.
NG: Repair or replace harness.
- CHECK BCM OUTPUT SIGNAL
- Connect BCM.
- Turn ignition switch ON.
- Check voltage between BCM connector M20 terminal 69 and ground.
69 - Ground: Battery voltage
Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK: Replace power window and door lock/unlock switch RH.
Refer to "FRONT DOOR ".
NG: Replace BCM. Refer to "BCM ".