LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Brake Control System) >> VDC/TCS/Abs >> Actuator And Electric Unit (Assembly) >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system. Refer to "BLEEDING BRAKE SYSTEM ".
  1. Position ABS actuator and electric unit (control unit) in vehicle.
  2. Connect brake pipes and bolts temporarily.
  3. Tighten bolts and brake pipes to specification. Refer to "HYDRAULIC CIRCUIT ".
  4. Connect ABS actuator and electric unit (control unit) harness connectors.
  5. Install and connect high-pressure and low-pressure A/C pipes. Refer to "COMPONENTS ".
  6. Install windshield wiper and linkage assembly. Refer to "INSTALLATION ".
  7. Connect battery negative terminal.
  8. Evacuate and recharge the A/C system. Refer to "HFC-134A (R-134A) SERVICE PROCEDURE ".
  9. Adjust the steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION ".
scientia non olet · About LEMON Manuals