LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 895 (Wiper, Washer & Horn) >> Front Wiper And Washer System >> Wiper Motor and Linkage >> Installation

Wiper Motor and Linkage: Installation

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not drop the wiper motor or cause it to contact other parts.
  • Check the grease conditions of the motor arm and wiper link joint(s). Apply grease if necessary.
  1. Operate front wiper motor one full cycle, then turn "OFF" (Auto Stop).
  2. Disconnect wiper motor connector. Operate front wiper motor one full cycle, then turn "OFF" (Auto Stop).
  3. Install wiper motor to bracket and wiper link, and install assembly to the vehicle.

    Wiper motor assembly bolts: 3.8 - 5.1 N.m (0.39 - 0.52 kg-m, 33.9 - 45.1 in-lb) 

  4. Connect wiper motor connector. Turn the wiper switch ON to operate the wiper motor, then turn wiper switch OFF (auto stop).
  5. Install cowl top cover. Refer to "REMOVAL AND INSTALLATION ".
  6. Install wiper arms. Refer to "FRONT WIPER ARMS ".
scientia non olet · About LEMON Manuals