WASHER TANK: Removal and Installation

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL

Remove the washer tank filler tube (1).

Fig 1: Removing Washer Tank Filler Tube
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove RH front tire. Refer to "ADJUSTMENT ".
Position the RH fender protector back. Refer to "EXPLODED VIEW ".
Remove engine undercover.
Remove side undercover.
Disconnect the washer pump and washer fluid level sensor connectors (C), then detach the connector harness clip (B).
Remove the washer tank bolts (A), disconnect the washer pump hose and remove the washer tank (1).

Fig 2: Identifying Washer Pump And Washer Fluid Level Sensor Connectors With Connector Harness Clip

Courtesy of NISSAN MOTOR CO., U.S.A.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, add Nissan specified fluid up to the upper level of washer tank inlet, and check for leaks. Refer to "FOR NORTH AMERICA: FLUIDS AND LUBRICANTS ".