LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> Component Diagnosis >> U1000 Can Comm Circuit >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
  1. CHECK DTC DETECTION

    With CONSULT-III

    1. Turn ignition switch ON.
    2. Start engine and wait for at least 6 seconds.
    3. Perform "Self Diagnostic Results" in "TRANSMISSION".

    With GST

    Follow the procedure "With CONSULT-III".

    Is "U1000 CAN COMM CIRCUIT" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: Refer to "INTERMITTENT INCIDENT ".

scientia non olet · About LEMON Manuals