LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> Component Diagnosis >> P0615 Start Signal >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always drive vehicle at a safe speed.
NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
  1. CHECK DTC DETECTION

    With CONSULT-III

    1. Turn ignition switch ON.
    2. Perform "Self Diagnostic Results" in "TRANSMISSION".

    Is "P0615 STARTER RELAY/CIRC" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: Refer to "INTERMITTENT INCIDENT ".

scientia non olet · About LEMON Manuals