2. Check At Idle
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ENGINE START
- Park vehicle on flat surface.
- Move A/T selector lever to P position.
- Turn ignition switch to OFF position.
- Turn ignition switch to START position.
- Is engine started?
Yes or No
- Yes: GO TO 2.
- No: Mark the box on the DIAGNOSTIC WORKSHEET. Go to 2. ENGINE CANNOT BE STARTED IN P AND N POSITION . Continue ROAD TEST.
- CHECK ENGINE START
- Turn ignition switch to ACC position.
- Move A/T selector lever to D , 1 , 2 or R position.
- Turn ignition switch to START position.
- Is engine started?
Yes or No
- Yes: Mark the box on the DIAGNOSTIC WORKSHEET. Go to 2. ENGINE CANNOT BE STARTED IN P AND N POSITION . Continue ROAD TEST.
- No: GO TO 3.
- CHECK VEHICLE MOVE
- Move A/T selector lever to P position.
- Turn ignition switch to OFF position.
- Release parking brake.
GO TO 4.
- CHECK VEHICLE MOVE
- Push vehicle forward or backward.
- Does vehicle move when it is pushed forward or backward?
- Apply parking brake.
Yes or No
- Yes: Mark the box on the DIAGNOSTIC WORKSHEET. Go to 3. IN P POSITION, VEHICLE MOVES FORWARD OR BACKWARD WHEN PUSHED . Continue ROAD TEST.
- No: GO TO 5.
- CHECK VEHICLE MOVE
- Start engine.
- Move A/T selector lever to N position.
- Release parking brake.
- Does vehicle move forward or backward?
Yes or No
- Yes: Mark the box on the DIAGNOSTIC WORKSHEET. Go to 4. IN N POSITION, VEHICLE MOVES . Continue ROAD TEST.
- No: GO TO 6.
- CHECK SHIFT SHOCK
- Apply foot brake.
- Move A/T selector lever to R position.
- Is there large shock when changing from N to R position?
Yes or No
- Yes: Mark the box on the DIAGNOSTIC WORKSHEET. Go to 5. LARGE SHOCK. N --> R POSITION . Continue ROAD TEST.
- No: GO TO 7.
- CHECK VEHICLE MOVE
- Release foot brake for several seconds.
- Does vehicle creep backward when foot brake is released?
Yes or No
- Yes: GO TO 8.
- No: Mark the box on the DIAGNOSTIC WORKSHEET. Go to 6. VEHICLE DOES NOT CREEP BACKWARD IN R POSITION . Continue ROAD TEST.
- CHECK VEHICLE MOVE
- Move A/T selector lever to D , 2 and 1 positions and check if vehicle creeps forward.
- Does vehicle creep forward in all three positions?
Yes or No
- Yes: Go to 3. CRUISE TEST .
- No: Mark the box on the DIAGNOSTIC WORKSHEET. Go to 7. VEHICLE DOES NOT CREEP FORWARD IN D , 2 OR 1 POSITION . Continue ROAD TEST.