LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 773 (Clutch System QG18DE) >> Clutch Master Cylinder >> Installation

Clutch Master Cylinder: Installation

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install reservoir hose.
  2. Connect clutch tube to master cylinder assembly, and hand-tighten flare nut.
  3. Install master cylinder assembly to cowl, and tighten mounting nuts to the specified torque.
    1. : 10.8 - 14.6 N.m (1.1 - 1.4 kg-m, 8 - 10 ft-lb) 
  4. Tighten reservoir tank bracket mounting nuts to the specified torque.
    1. : 2.9 - 5.9 N.m (0.29 - 0.60 kg-m, 26 - 52 in-lb) 
  5. Tighten clutch tube flare nut using a flare nut torque wrench to the specified torque.
    1. : 15 - 18 N.m (1.5 -1.8 kg-m, 11 - 13 ft-lb) 
  6. After installing clevis pin, install snap pin to connect clutch pedal to push rod.
  7. After finishing the operation, bleed air from clutch piping. Refer to BLEEDING PROCEDURE .
scientia non olet · About LEMON Manuals