LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Engine Controls Self-Diagnostics - Pathfinder & QX4) >> Diagnostic Tests >> DTC P0340: Camshaft Position Sensor (Phase) >> DTC Confirmation Test (Malfunction "A")

DTC Confirmation Test (Malfunction "A")

WARNING: This page is about a different car, the 2002 Nissan Pathfinder and 2002 Infiniti QX4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding, ensure battery voltage is more than 10.5 volts with ignition on. If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing.
  1. Turn ignition on. Select DATA MONITOR mode with scan tool. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  2. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  .
scientia non olet · About LEMON Manuals