DTC Confirmation Test
WARNING: This page is about a different car, the 2002 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Malfunction is detected when rear HO2S heater circuit current is out of normal range. Possible causes are:
- HO2S heater circuit open or shorted.
- Defective HO2S heater.
To set DTC, turn ignition on. Select DATA MONITOR with scan tool. Drive vehicle at a speed of more than 43 MPH for 2 consecutive minutes. Stop vehicle and let engine idle for 6 seconds. If first trip DTC is detected, perform DIAGNOSTIC PROCEDURE .