DTC Confirmation Test (DTC P1336)
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
Malfunction is detected when ECM detects chipping of flywheel or drive plate teeth. Possible causes are:
- CKP sensor circuit open or shorted.
- Defective CKP sensor.
- Damaged flywheel or drive plate.
To set DTC, turn ignition on. Using scan tool, select DATA MONITOR. Start engine and let it idle for at least 4 minutes. If first trip DTC is detected, perform DIAGNOSTIC PROCEDURE .