LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Self-Diagnostics - 1.8L - XE, GXE) >> Diagnostic Tests >> DTC P1444: EVAP Canister Purge Volume Control Solenoid Valve >> DTC Confirmation Test

DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC confirmation test has been previously performed, always turn ignition off and wait at least 10 seconds before performing next DTC confirmation test.
NOTE: Before proceeding, ensure ambient temperature is more than 41°F (5°C).

With CONSULT-II

  1. Start engine and warm to normal operating temperature.
  2. Turn ignition off and wait at least 10 seconds. Turn ignition on.
  3. Select PURG VOL C/V P1444 of EVAPORATIVE SYSTEM in DTC WORK SUPPORT mode with CONSULT-II.
  4. Press START. Start engine and let it idle until TESTING on CONSULT-II changes to COMPLETED (it will take about 10 seconds).
  5. If TESTING is not displayed after 5 minutes, retry from step  2 .
  6. Press SELF-DIAG RESULTS. If NG is displayed, go to DIAGNOSTIC PROCEDURE  .
  7. If OK is displayed, system is okay at this time.

With Generic Scan Tool

  1. Start engine and warm to normal operating temperature. Turn ignition switch off and wait at least 10 seconds. Start engine and let it idle for at least 20 seconds.
  2. Select MODE 7 with scan tool. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals